pino-tech.eu
Products => SoilWatch 10 => Topic started by: Kalliandra on September 18, 2018, 02:10:12 PM
-
Hi,
My sensors came today here in Brasil.
I will star to make the callibration today.
When I have the results i post here.
Thanks!
-
Hi,
Great! It will help a lot.
Everybody like colourful charts. At least I do!
I hope you have seen the other topic with calibration https://pino-tech.eu/forum/soilwatch-10/soilwatch10-(-3v)-and-soil-moisture-vol/ (https://pino-tech.eu/forum/soilwatch-10/soilwatch10-(-3v)-and-soil-moisture-vol/)
Thanks for sharing.
-
Hi,
Yes I see this topic.
I have two tipes of soil's in hand and two tipes of sensor too(soilwatch 10 and decagon 10hs).
I'll make the calibration using the method that decagon sugest. (http://www.decagon.com.br/assets/Videos/How-To/Calibrate_Soil.flv).
When i have the results i will post here.
Thanks
-
Hi,
i have done some calibrations with the sensor. I use two soil's from different pivot's(p04 is sand and p01 is sandy clay) with two depths(0-20cm and 20-40cm), so I have four samples of soil. I make a calibration for each one and a generic calibration for the tour tipes combined.
The X axis is milivolts and the Y is VWC %
-
Great stuff. thanks for sharing !
-
Kalliandra,
Many thanks for the Graphs that you have shared with us.
I needed to know a few things,
Can you share me how you are measuring the VWC% of the Soil, can you please tell the method and the math that you are using to evaluate the VWC.
I sincerely thanks for the information you provided.
-
Kalliandra,
Many thanks for the Graphs that you have shared with us.
I needed to know a few things,
Can you share me how you are measuring the VWC% of the Soil, can you please tell the method and the math that you are using to evaluate the VWC.
I sincerely thanks for the information you provided.
Hi Aylashiv, Sorry for delay!
I see that pinotec made a little diferent procedure than I, but i think is tha same result.
If you need some help you are free to send me a PM.
Regards,
Gabriel